I bought this cheap bathroom vanity off of amazon and we assembled it. We cannot get the drawers on. These silver things get in the way. When I get them mounted in a way I feel is correct they prevent the drawer from closing all the way. I haven’t dealt with anything like this.
Does anyone know how to mount it? I’m sure once its done Ill feel like an idiot for how simple it is.
Thanks
Can you flip them so the silver part is in the middle?
Flip them? they slide along the inside of the slide
Like
[]
Instead of
[[
Is there a video I could reference?
Sorry. But if you look at the cross section it’s what I showed you.
Take one out, flip it over so the hollow parts of both are in the middle.
[ ]
The silver things are runners with ball bearings that drawer slides on. The slides that attach to the drawer will snap into these silver runners.
Usually, you just need to align the slides on the drawer with the runners and push. They should snap in. The runners tend to slide around while connecting them. If they slide to the back, it’s ok, they will still connect once you get them lined up and push the drawer into them. If you can reach from underneath, you can hold the runner in place while attaching the drawer. Do one side at a time.
If you’re struggling to get it to connect, I recommend removing the slide from the side of the drawer and seeing if you can get a single slide to attach to the runner. It will click when it attaches. By doing just one, you might have an easier time seeing how it connects.
Once you figure it out, you’ll need to disconnect it. There should be a little plastic lever that you hold down (or up, depending on the side) while you pull out the slide. Put it back on the drawer and see if you can connect it once it’s back on the drawer.
They are a little complicated, but once you see how it goes together, it should make sense. If what I said is still confusing or if you are still struggling, reply and I’ll see if I can get some pictures to explain it better.
- Edit: A common mistake I’ve seen is putting the slides on the drawer backwards. The part attached to the drawer should have the flat part against the drawer. The drawer should look like this ]|_______|[
That’s a much better explanation then I was attempting.
Thanks Sata . . . What the fuck is wrong with you? Who hurt you? You will live rent free in my head for a long time. Just so you know, I hate you for that. You magnificent bastard, you. Bravo. Bra fucking vo. 👏👏
Thanks for everything, guys! My sister put the slides on backward! I got it on!