Also, how did you get into it, and what sort of education or certifications (if any) did you need?
And if you were to get into the same niche today, would you? (And in some cases–COULD you, or has the door closed?)
Also, how did you get into it, and what sort of education or certifications (if any) did you need?
And if you were to get into the same niche today, would you? (And in some cases–COULD you, or has the door closed?)
I’m a kiln operator. I run a giant oven to dry red and white pine.
Dropped out of uni. Various retail and tech jobs for about 12 years. 4 years disability. Took an interview at a lumber mill because ‘cool tour’, took a job because ‘paycheck for a little while anyway’. Ran a planer for about 6 weeks and then offered kiln operator when their previous was poached.
On the job learning for me with the caveat that it was not a reasonable expectation to set. Typically one works under a senior operator for about two years not ‘you’re on your own but you’re good at google right?’
Certified by my work for government heat treatment programs, front loader/forklift operation and working at heights. One of those jobs where mindset is more important than education.
Would I do it again? Yes? I’d want more money for the work. There’s not a lot of people who will write an algorithm to interpret the data they gather in a 50c box. It’s a really intense combination of intellectual and manual labor and the compromise seems to be to plop the pay in the middle. Good pay for a lumber mill but shit pay for developing processes, an inventory system and an entire goddamned iOS app(that my boss didn’t even understand much less appreciate).
I wouldn’t expect the door to be open again in the future. There’s not a lot of kilns to run, they are increasingly automated and it’s a job people hold til retirement. The manager who hired me took a massive gamble on a physically disabled but intelligent person so that’s not easy to find either. Owner runs under the ‘warm body is better than no body’ premise. There’s not even any other mills close enough with kilns that I have other employment opportunities. I’ve got a very specific and reasonably lucrative skill set for a rare job.
Ok are you the guy to blame for this dripping wet, warped shit I’m paying through the nose for?
Someone like me…sort of.
Warp is more about the piling and stickering of the packs going into the kiln. Wet you can mitigate at home but once a warp is set you’re pretty much screwed.
The mill should have some sort of quality control in place to communicate these issues between the kilns and stacker crew. Find a different mill to buy from. Anything warped is pulled out before the planer at my mill and then sold as rough outs or goes to the chipper.
Ever seen 20 feet high of stacked lumber sway in the wind? Stickering can be a huge safety issue alongside quality.